A practical reference on Semax: what it is, how it behaves, what the literature reports, and where the honest uncertainties sit.
This page was last updated on 2025-10-27 and is reviewed periodically as new material appears.
Peptide stability depends strongly on temperature, moisture, and pH. Lyophilized Selank is generally most stable when stored cold and dry, with freezer temperatures commonly used for long-term storage. In solution, the compound is susceptible to hydrolysis and to microbial growth if it is not handled aseptically. The C-terminal proline-rich extension appears to slow enzymatic cleavage relative to tuftsin, though quantitative degradation rates vary with the matrix and the conditions tested. Published stability data specific to Selank remain sparse.
Quality assessment of Selank samples typically combines purity determination with identity confirmation and counter-ion analysis. Purity is usually reported as a percentage by chromatographic area, with values above 95 percent often quoted for research-grade material. Water content and residual solvents are checked in lyophilized batches because they affect both stability and accurate mass determination. A reported purity figure does not by itself establish that a sample is the intended sequence, so orthogonal methods are needed to rule out sequence isomers or truncation products.
Characterization of Selank in laboratory settings relies on standard peptide analytical techniques. Reverse-phase high-performance liquid chromatography separates the peptide from related impurities and degradation products, while mass spectrometry confirms molecular identity through accurate mass measurement. Amino acid analysis and peptide sequencing verify the primary structure when reference material is unavailable. Because Selank is a short chain, fragmentation-based analysis produces a diagnostic ion pattern that supports confident identification.
Selank is a hydrophilic peptide and dissolves readily in water and in aqueous buffers. The lyophilised powder is typically a white to off-white solid. Because short peptides are prone to hydrolysis and oxidation, handling benefits from limiting exposure to heat, moisture and strong light. Working solutions are commonly prepared in sterile water or saline, and repeated freeze-thaw cycles are avoided to reduce aggregation and loss of activity. These practices reflect general laboratory convention rather than published stability specifications.
Dry powder is normally held at -20 degrees Celsius or lower, in a sealed container with desiccant and protection from light. Reconstituted solutions are usually kept at 2 to 8 degrees Celsius for short periods and frozen for longer ones. Proline residues at several positions are generally associated with some resistance to peptidase attack, but chemical stability still declines at neutral to alkaline pH and at elevated temperature. Exact shelf-life figures are product-specific and are not standardised across suppliers.
Identity and purity are usually assessed by reversed-phase high-performance liquid chromatography, with mass spectrometry used to confirm molecular mass and sequence information. Amino acid analysis and peptide mapping may supplement these methods. Certified reference standards are scarce, and many commercial lots are sold as research chemicals without a pharmacopoeial monograph. Regulatory treatment differs by country: Selank is a registered prescription medicine in Russia, while in the European Union and the United States it is not an approved drug and may fall under research-chemical or unapproved-product frameworks.
| Property | Value | Notes |
|---|---|---|
| Typical storage temperature | -20 °C or below | For lyophilized powder, long term |
| Common analytical method | Reverse-phase HPLC | Usually paired with mass spectrometry |
| Typical reported purity | At or above 95 percent by area | Research-grade material |
| Aqueous solubility | High | Solutions used in laboratory assays |
| Moisture sensitivity | Hydrolyzes in solution | Aseptic handling reduces degradation |
Development work on the compound began in the 1980s and 1990s at the Institute of Molecular Genetics in Moscow, within the same research programme that produced the peptide Semax. Early investigators sought a tuftsin derivative with improved resistance to enzymatic breakdown and with activity in the central nervous system after peripheral administration. Most of the primary literature from this period was published in Russian, a factor that still shapes how easily the findings can be checked by outside groups.
Naming for this compound is not fully standardised in English sources. The spelling Selanc appears in some transliterations, and catalogue entries may instead list the peptide sequence itself as the identifier. Reference material sometimes groups it with other short synthetic peptides studied for behavioural effects, which can create confusion when citations are compared. Distinguishing the exact sequence from related tuftsin analogues is therefore a practical first step when reviewing any dataset or specification sheet.
Selank is a synthetic heptapeptide with the sequence Thr-Lys-Pro-Arg-Pro-Gly-Pro, frequently abbreviated as TKPRPGP. It was designed as a structural analogue of tuftsin, a naturally occurring tetrapeptide released by enzymatic cleavage of the immunoglobulin heavy chain. The two additional proline residues at the C-terminal end extend the parent chain and change how the molecule behaves in solution. The free peptide has a calculated molecular mass of approximately 751.9 g/mol and is generally supplied as a lyophilised white to off-white powder.
Selank is a synthetic heptapeptide developed in Russia as a structural analogue of tuftsin, a naturally occurring immunomodulatory tetrapeptide. Its sequence, Thr-Lys-Pro-Arg-Pro-Gly-Pro, keeps the tuftsin core at the N-terminus and appends a Pro-Gly-Pro tail. Researchers at the Institute of Molecular Genetics in Moscow synthesized the compound during the 1990s while searching for peptides with combined anxiolytic and immunomodulatory activity. The added tail was intended to resist enzymatic cleavage and prolong the molecule's presence in circulation.
The compound has a calculated molecular weight near 751.9 daltons and carries a net positive charge at physiological pH because of its arginine residue. It dissolves freely in water and in common aqueous buffers, and typically appears as a white or off-white lyophilized powder. The amide backbone makes the molecule susceptible to peptidases, which limits oral use and favors intranasal or parenteral routes. Nomenclature in the literature varies: the substance is also described by the sequence abbreviation TP-7 and by a Russian trade designation.
Regulatory status differs sharply by region. Selank holds a Russian marketing authorization, where it is supplied mainly as nasal drops, while authorities elsewhere have not approved it for medical use. Material sold internationally is therefore usually labeled as a research chemical rather than a medicine. Peer-reviewed publications come predominantly from Russian laboratories, and sample sizes are generally small. Whether the compound produces comparable effects under independent, well-controlled replication remains an open question that the broader literature has not settled.
Development took place at the Institute of Molecular Genetics of the Russian Academy of Sciences, where a series of short peptides were designed in the 1980s and 1990s. Selank was selected from variants of tuftsin that showed resistance to plasma peptidases. Russian regulatory approval covers it as an anxiolytic agent given intranasally. Outside that market the compound is normally handled as a research chemical rather than a medicine, and no widely recognised international pharmacopoeial monograph exists. The name Selank is a coined trade designation rather than a systematic chemical name.
Enzymatic stability motivates the extra three residues at the carboxyl end. Native tuftsin is cleaved quickly by circulating aminopeptidases and carboxypeptidases, which limits its duration of action and its usefulness as a tool compound. Extending the chain with proline-rich segments is a common design tactic because proline constrains the backbone and slows proteolysis. The same Pro-Gly-Pro motif appears in other Russian-developed peptides of the era. Whether the full seven-residue chain is required for activity, or whether it acts mainly as a prodrug releasing tuftsin, remains unresolved.
Selank is a synthetic heptapeptide with the sequence Thr-Lys-Pro-Arg-Pro-Gly-Pro. Its four N-terminal residues reproduce tuftsin, a tetrapeptide fragment of the immunoglobulin heavy chain, while the C-terminal Pro-Gly-Pro extension is a synthetic addition. The peptide has a molecular mass near 752 daltons and carries a net positive charge at physiological pH because of the arginine and lysine side chains. Published indexes list it under the name Selank and the sequence abbreviation TKPRPGP. Solid-phase peptide synthesis is the standard production route for research quantities.
The set point theories of hunger and eating are a group of theories developed in the 1940s and 1950s that operate under the assumption that hunger is the result of an energy deficit and that eating is a means by which energy resources are returned to their optimal level, or energy set point. According to this assumption, a person's energy resources are thought to be at or near their set point soon after eating, and are thought to decline after that. Once the person's energy levels fall below a certain threshold, the sensation of hunger is experienced, which is the body's way of motivating the person to eat again. The set point assumption is a negative feedback mechanism. Two popular set point theories include the glucostatic set point theory and the lipostatic set point theory. The set point theories of hunger and eating present a number of weaknesses.
==== The storage iron pool ==== Iron can be stored in ferritin as ferric iron due to the ferroxidase activity of the ferritin heavy chain. Dysfunctional ferritin may accumulate as hemosiderin, which can be problematic in cases of iron overload. The ferritin storage iron pool is much larger than the labile iron pool, ranging in concentration from 0.7 mM to 3.6 mM.
13 March – Five people are taken to hospital for treatment after a bus crashes into a high rise block of flats in Paisley, Glasgow. 14 March – The Scottish Parliament Corporate Body finds Michael Matheson in breach of the Ministerial Code over his £11,000 iPad bill. Mountaineer Anna Wells becomes the first woman to reach the top of all of Scotland's 282 Munros in one winter season. 15 March – Following trial and conviction at the High Court in Glasgow, double murderer Peter Duffy is sentenced to at least 30 years in prison for the murder of his wife, Emma Baillie, and brother, John-Paul Duffy, in separate incidents in Coatbridge in 2022. 17 March – HMP Kilmarnock becomes the first privately run prison in Scotland to pass into the ownership of the Scottish Prison Service after its contract with Serco comes to an end. 19 March – Scottish Prison Service director Allister Purdie gives evidence to the Scottish COVID-19 Inquiry, and apologises to the family of Callum Inglis, who died at Addiewell Prison during the pandemic, after his family learned of the death through word of mouth before they were told formally by prison authorities. 21 March – The Scottish Parliamentary Corporate Body confirms that members of Scottish Parliament staff will no longer be allowed to wear rainbow lanyards, or any other badge or jewellery associated with social issues, while at Holyrood. The Wildlife Management and Muirburn (Scotland) Bill passes its final vote in the Scottish Parliament.
Sources: en.wikipedia.org
Day of Defeat received "generally favorable reviews" according to the review aggregation website Metacritic. IGN praised the game for its use of narrow spaces to stimulate the game's "relentless pacing", and GameSpy spoke highly of its attention to detail. Reviewers also praised Day of Defeat for its promotion of teamwork through purposefully tight corridors that force players to cooperate, lest they be killed by an enemy outside their field of vision. Both GameSpy and GameSpot levied criticism against the game for its sub-par visuals and "downright ugly" color palette, blaming the aging GoldSrc engine for the aesthetic issues. Many reviewers drew parallels between Day of Defeat and Battlefield 1942, the latter of which had been released only six months prior to the former. Both games were set in World War II and featured gameplay that was heavily reliant on their respective class-based systems, which lead reviewers to make direct comparisons between the two in their reviews of Day of Defeat. The game was also faulted for its lack of usable vehicles, contrasting Battlefield's usage of operable vehicles as a key gameplay component. PC Gamer US awarded Day of Defeat its 2001 "Mod of the Year" prize. The editors wrote, "Made by amateur developers not yet of American drinking age, Day of Defeat absorbed entire weeks of office LAN play."
=== Absorption === Estradiol is well-absorbed regardless of route of administration. However, the bioavailability of estradiol differs substantially with different routes of administration. Oral estradiol has an average bioavailability of around 5%, requiring relatively high dosages of estradiol for effects. Estradiol administered in the form of an ester by intramuscular or subcutaneous injection has complete bioavailability.
=== Enzyme regulation === The activity of some enzymes is regulated by ADP-ribosylation. For instance, the activity of Rodospirillum rubrum di-nitrogenase-reductase is turned off by ADP-ribosylation of an arginine residue, and reactivated by the removal of the ADP-ribosyl group.
is the liquid-air surface tension (force/unit length), θ is the contact angle, ρ is the density of liquid (mass/volume), g is the local acceleration due to gravity (length/square of time), and r is the radius of tube. As r is in the denominator, the thinner the space in which the liquid can travel, the further up it goes. Likewise, lighter liquid and lower gravity increase the height of the column. For a water-filled glass tube in air at standard laboratory conditions, γ = 0.0728 N/m at 20 °C, ρ = 1000 kg/m3, and g = 9.81 m/s2. Because water spreads on clean glass, the effective equilibrium contact angle is approximately zero. For these values, the height of the water column is
Sources: en.wikipedia.org
The most common approach combines reverse-phase liquid chromatography with mass spectrometry. Chromatography separates the components while mass spectrometry confirms the molecular mass. Peptide sequencing or tandem mass analysis can further verify the amino acid order.
Lyophilized powder is usually kept frozen and protected from moisture. Solutions are less stable and are often used promptly or divided into aliquots to avoid repeated freeze-thaw cycles. Exact shelf-life values depend on purity and handling.
No. A purity figure derived from chromatographic area does not prove the amino acid sequence. Identity requires an orthogonal method such as mass spectrometry or sequencing. Truncated or isomerized peptides can co-elute with the target compound.
Dry powder is normally held at -20 degrees Celsius or below in a sealed, light-protected container with desiccant. Brief room-temperature handling during weighing is generally tolerated. Storage instructions vary between suppliers, so the accompanying certificate of analysis should be followed.