This is a working overview of Selank, written for readers who want more than a one-paragraph summary but less than a textbook.
Reviewed 2026-06-02. Anything still debated is marked as such rather than presented as settled.
Lyophilised material kept dry at minus 20 degrees Celsius or colder is the most stable form, and suppliers commonly state a shelf life of two years or more under those conditions. Once dissolved, degradation accelerates through hydrolysis and deamidation, particularly at alkaline pH or elevated temperature. Working solutions are usually divided into single-use aliquots to avoid repeated freeze-thaw cycles. The choice of reconstitution solvent affects both stability and the ionic strength of the final preparation.
Reverse-phase high-performance liquid chromatography with ultraviolet detection near 214 nanometres is the standard purity method. Mass spectrometry, typically electrospray ionisation, confirms identity through the expected mass-to-charge pattern. Amino acid analysis can verify composition independently. Chiral purity requires separate techniques such as derivatisation followed by chromatographic separation, and such data are rarely reported for research-grade material.
Quantification in biological matrices relies on liquid chromatography coupled to tandem mass spectrometry with stable-isotope internal standards. Low plasma concentrations and adsorption to container surfaces both complicate measurement. Solid-phase extraction is often needed to reduce matrix interference before injection. Reported limits of quantification differ widely between laboratories, which makes direct comparison of pharmacokinetic results difficult and limits meta-analysis.
Reversed-phase high-performance liquid chromatography is the standard technique for estimating peptide purity. The result is a peak-area percentage, which describes how much of the detected material elutes as the main peak in one run. Mass spectrometry confirms the molecular mass and can reveal truncated, adducted, or otherwise modified species. Amino acid analysis or tandem mass spectrometry can address sequence fidelity when identity is in doubt. None of these measurements, taken alone, establishes that a sample is fit for any specific purpose.
Lyophilized selank is normally supplied as a dry powder and is considered stable for extended periods when kept cold and dry. Moisture uptake is the main practical threat, because absorbed water promotes both hydrolysis and aggregation in the solid state. Vials are usually warmed to room temperature before opening so that condensation does not form on the powder. Supplier documentation commonly specifies -20 °C for routine storage, with -80 °C used for material intended to be archived for years.
| Property | Value | Notes |
|---|---|---|
| Dry storage temperature | -20 C or below | Sealed, desiccated, protected from light |
| Solution stability | Hours to days at 2-8 C | Depends on buffer and microbial load |
| Preferred pH range | Near neutral to slightly acidic | Alkaline pH accelerates hydrolysis |
| Main degradation routes | Hydrolysis and deamidation | No cysteine or methionine in sequence |
| Identity confirmation | Electrospray mass spectrometry | Observed mass compared with 751.9 Da |
The compound was designed at the Institute of Molecular Genetics of the Russian Academy of Sciences during the 1980s and 1990s. The stated design goal was to retain the immunomodulatory and central nervous system activity attributed to tuftsin while improving resistance to enzymatic breakdown. Adding a proline-rich tail to the short parent peptide was a deliberate strategy, because proline residues restrict the conformations available to many peptidases. The same laboratory produced Semax, an ACTH fragment analog, and both compounds were developed in parallel as short, enzymatically stabilized peptides intended for intranasal use.
Selank is not a naturally occurring peptide and has no known endogenous counterpart in human physiology. Russian-language sources frequently call it TP-7, while English-language sources use the name Selank almost exclusively. Database indexing is uneven, partly because early reports appeared in regional journals that are not widely cataloged. Some summaries describe the material as a tuftsin analog and others as a synthetic heptapeptide; the labels overlap rather than conflict. Citing the primary sequence resolves ambiguity more reliably than the research or trade name alone.
Selank is a synthetic heptapeptide with the sequence Thr-Lys-Pro-Arg-Pro-Gly-Pro, written TKPRPGP in one-letter notation. Its structure consists of the immunomodulatory tetrapeptide tuftsin, Thr-Lys-Pro-Arg, extended at the carboxyl terminus by a Pro-Gly-Pro segment. The molecular formula is commonly given as C33H57N11O9, corresponding to a monoisotopic mass near 751.4 Da and an average molecular mass near 751.9 Da. All seven residues are proteinogenic amino acids, and the molecule carries no modified side chains or non-natural linkages.
Characterization of Selank in a laboratory setting relies on standard peptide methods. Reverse-phase high-performance liquid chromatography separates the target from related impurities and provides a purity figure, commonly reported as 95 percent or higher. Mass spectrometry, typically electrospray ionization or matrix-assisted laser desorption, confirms the molecular mass and helps detect truncation or modification. Amino acid analysis can verify composition when a sequence-level check is needed. These techniques together establish identity and purity for a given lot.
Lyophilized Selank, the dry powder form, is generally stored frozen at minus 20 degrees Celsius or colder for long-term keeping. The solid is hygroscopic and should stay sealed, dry, and protected from light. Once dissolved, the peptide is less stable and is usually held refrigerated at 2 to 8 degrees Celsius for short periods. Repeated freezing and thawing is avoided because it can promote aggregation and loss of activity. Buffers and pH choice also affect how long a solution remains usable.
Proteoglycans - Including chondroitin sulfate and heparan sulfate, which bind to collagen and may regulate collagen fibril diameters and play a role in mineralization Osteocalcin - A bone-specific protein involved in binding calcium during the mineralization process Osteonectin - May serve a bridging function between collagen and the mineral component Bone sialoprotein - Proteins rich in sialic acid that participate in matrix organization Growth factors - Including transforming growth factors, fibroblast growth factors, and insulin-like growth factors
== Fuel resources == Breeder reactors could, in principle, extract almost all of the energy contained in uranium or thorium, decreasing fuel requirements by a factor of 100 compared to widely used once-through light water reactors, which extract less than 1% of the energy in the actinide metal (uranium or thorium) mined from the earth. The high fuel-efficiency of breeder reactors could greatly reduce concerns about fuel supply, energy used in mining, and storage of radioactive waste. With seawater uranium extraction (currently too expensive to be economical), there is enough fuel for breeder reactors to satisfy the world's energy needs for 5 billion years at 1983's total energy consumption rate, thus making nuclear energy effectively a renewable energy. In addition to seawater, the average crustal granite rocks contain significant quantities of uranium and thorium that with breeder reactors can supply abundant energy for the remaining lifespan of the sun on the main sequence of stellar evolution.
Gas phase regioselectivity is calculated to favor 1,5 addition over 1,4 addition by up to 2.9 kcal/mol in activation energy in the gas phase; solvation corrections give the same energy barriers for both regioisomers, explaining the regioisomeric mix that results from DIFO cycloadditions. While the 1,4 isomer is disfavored by its larger dipole moment (all electron-rich substituents on one side), solvation stabilizes it more strongly than the 1,5 isomer, eroding regioselectivity. Experimental studies by Carolyn R. Bertozzi report a nearly 1:1 ratio of regioisomers, confirming the predicted lack of regioselectivity in the addition. Furthermore, nearly all of the distortion energy (92%) arises from the distortion of the 1,3 dipole rather than the cyclooctyne, which has a pre-distorted ground state geometry that increases its reactivity. Fluorination decreases the distortion energy by allowing the transition state to be achieved with a lesser distortion of the 1,3-dipole during a reaction, resulting in a larger dipole angle.
) is typically set to a value of 1 to increase the readability of the exchangeability parameter estimates (since it allows users to express those values relative to chosen exchangeability parameter). The practice of expressing the exchangeability parameters in relative terms is not problematic because the
Atrocities occurred in the conflict long before France ratified the 1949 Geneva Conventions on June 28, 1951, in which such acts committed afterwards in violation of the Conventions' provisions in force became war crimes. Common Article 3 of the 1949 Geneva Conventions contains a minimum protection that only applies to humane treatment in a non-international conflict (i.e., war by a state against non-state armed groups or between non-state armed groups themselves). For the purpose of this section, however, atrocities committed before or after France's ratification of the 1949 Geneva Conventions are included.
Sources: en.wikipedia.org
SXXK motif is located at the N-terminal end of α2 helix and includes two residues that are important for the enzyme function. Ser-310 : Includes a serine nucleophile that is acylated by both peptide substrate and β-lactam antibiotics. Lys-313 : Plays an important role in providing the dense hydrogen bound network at the active site and is in distance of Ser 310, ASN-364 and the carbonyl backbone of Ser-362. SXN motif that includes Ser-362, Ser-363 and Asn-364 KTG motif that includes Lys-497, Thr-498 and Gly-499 Research also implies that adjacent regions to the active site which differ between different PBP have significant influence on the rate of β-lactam acylation rate.
== Research == At the Yale School of Medicine, Shulman has investigated the pathophysiology of insulin resistance, metabolic dysfunction-associated steatotic liver disease (MASLD), metabolic dysfunction-associated steatohepatitis (MASH), type 2 diabetes (T2D), and related cardiometabolic conditions. His laboratory developed and applied novel 13C, 31P, and 1H NMR techniques to measure intracellular glucose, lipid, and mitochondrial metabolism in vivo. These methods allowed real-time, noninvasive assessment of metabolic fluxes in a tissue-specific manner. Early studies from his group identified defects in insulin-stimulated muscle glycogen synthesis, attributed to reduced glucose transport activity, in individuals with T2D. Later research extended these findings to individuals with prediabetes and obesity and demonstrated that exercise could bypass this defect and reverse muscle insulin resistance. Using 1H NMR, Shulman reported that intramyocellular lipid content strongly predicts muscle insulin resistance in both adults and children, and that hepatic lipid content is a strong predictor of hepatic insulin resistance in both humans and rodent models of MASLD. His team showed that lipid-induced insulin resistance in skeletal muscle stems from impaired glucose transport due to altered insulin signaling, challenging the classical Randle cycle hypothesis.
=== Accession talks terminated === Belarus Russia In May 2007, the OECD decided to open accession negotiations with Russia. In March 2014, the OECD halted membership talks in response to Russia's role in that year's Crimean annexation and continuous human and civil rights abuses. On 25 February 2022, the OECD terminated the accession process with Russia after it invaded Ukraine. In March 2022, Belarus was suspended from any participation in the OECD.
Buthionine sulfoximine (BSO) is a sulfoximine derivative which reduces levels of glutathione and is being investigated as an adjunct with chemotherapy in the treatment of cancer. The compound inhibits gamma-glutamylcysteine synthetase, the enzyme required in the first step of glutathione synthesis. Buthionine sulfoximine may also be used to increase the sensitivity of parasites to oxidative antiparasitic drugs.
Sources: en.wikipedia.org
Dry powder is best kept sealed, protected from light, and held at minus 20 degrees Celsius or below. Desiccant packaging helps limit moisture uptake because the material is hygroscopic. A sealed vial should be allowed to equilibrate to room temperature before opening to reduce condensation.
Hydrolysis of peptide bonds and deamidation of arginine and proline residues are the main degradation routes. Alkaline pH and higher temperatures accelerate both processes. Buffered, near-neutral solutions stored cold generally degrade more slowly than unbuffered ones.
Reverse-phase chromatography gives the clearest single view of related impurities and truncated sequences. Mass spectrometry then confirms that the main peak carries the expected mass. Neither test detects enantiomeric impurities, which require a separate chiral assay.
Sealed, desiccated storage at -20 °C or colder is the standard recommendation for research-grade material. Vials should reach room temperature before they are opened, which limits condensation. Repeated temperature cycling is discouraged.